Skip to main content

← All posts

Field Report

A Circuit Board and Its Metal Case in Seven Days

· 3 min read

Every TrailCurrent module comes in two halves: the circuit board that does the work and the case that protects it. For sixteen months, none of the CNC machines in our shop could make either one well. Then Makera sent us their Z1 Pro, a carving machine small enough to sit on a workbench. We unboxed it on a Saturday. By Friday, a two-sided circuit board cut on it had powered up on the bench and gone into a finned aluminum case cut on the same machine.

Why custom boards went on the shelf

Custom circuit boards were part of the plan from day one. We set them aside earlier this year, and retiring Torrent explains why: without a factory behind us, we could not keep custom boards going. At home, things were not much better. Our prototype process meant ironing a design onto copper with a t-shirt press and etching it in a chemical bath. It worked, but only for big, chunky designs, and the cases came off a 3D printer.

Two pieces that finally fit

Earlier this month NextPCB came on as our PCB partner. They make boards the right way, in batches, with the parts put on for you. What was still missing was the step before that: a fast way to try an idea on the bench before sending it off.

That is the gap the Z1 Pro fills. Draw a board, cut it, test it, fix it, cut it again, all in the same shop. Once it works, the design goes to NextPCB to be made properly. Together, that gets an idea onto the bench faster than we ever could before. Or, as the video puts it: if you can think it up and draw it up, a few days later it can be in your hands.

Custom boards are DevKits, prototypes for experienced builders, not finished products. You do not need a CNC to build TrailCurrent. If you just want a system that works, the off-the-shelf modules stay available and stay the path we recommend.

Lines thinner than a credit card

The test board is not an easy one. Two of its copper lines are less than half as wide as a credit card is thick, running side by side under a pair of tiny parts. Copper on both faces means a hole drilled from one side has to land dead center on the other. We have tried this exact board on other machines on the channel, and every time those lines broke and it was back to the chemicals. Watch the video to see whether they survived this time, and how we checked.

A case that keeps it cool

A 3D printed case holds a board, but it cannot pull heat away from it. A block of aluminum can. We drew this case around the board itself. A raised block under the lid presses down on the main chip through a soft thermal pad, and the heat rises into ten fins across the top. No fan, nothing to wear out, and that matters for electronics sitting in a closed-up rig all summer. The three plugs line up with openings in the back wall, so everything connects with the lid on.

Cross-section of the aluminum case. A pedestal in the lid presses on the module's main chip through a thermal pad, and the heat rises into ten fins open at both ends.
No fan. The case is the heat sink.

The part that won us over

The most impressive moment of the week came from a mistake. Halfway through cutting a board, the machine asked for a bit we did not have. On every other machine we own, that means starting over. What happened instead is in the video, along with the flip we had never once pulled off, and the step that did not go to plan at all. It ends with a straight verdict on whether you should buy one, and where it still falls short.

Get the files, or the machine

The board and case designs are free on GitHub, like everything else in TrailCurrent. If you want a machine of your own, here is the Makera Z1 Pro. The link carries our affiliate tag. It costs you nothing extra and sends a small cut back to the project.

Thank you to Makera for sending it our way. Follow along on the open source channel for the 4th axis, the laser and the first NextPCB boards. If you want a full video on how we cut the circuit boards, say so in the video comments.